FLIR DNB13TL2

45
Web Configuration
4. Click OK. An error message appears if the masks configured exceed 8%
of the total image area.
6.11 Network Service
Network Service contains the following sub-menus:
• DDNS
• PPPoE (Not supported)
6.11.1 DDNS
The DDNS sub-menu allows you to configure DDNS settings. Before
configuring DDNS settings, you must register the camera for a free FLIR
DDNS account (see “5. Configuring Remote Connection” on page 12).
To configure DDNS settings:
1. Cl
ick Netw
ork Service>DDNS.
2. Check Enable
DDNS.
3. Configure the f
ollowing:
• Provider: Select
FLIRDDNS.
• Domain Name: Enter the Domain Name you received from the
confirmation email you received after you created your DDNS account.
NOTE: Connect t
o
your camera using a web browser by entering http://,
the Domain Name, colon, and then the HTTP port. For example, if the
Domain Name is
tomsmith.myddns-flir.com , use the address 
http://tomsmith.myddns-flir.com:80 .
• User Name: Enter the User Name you received in the confirmation email.