35
Web Configuration
3. Under Max Disk Space, enter the disk full percentage that will trigger an
alarm (e.g. a Disk Full Alarm will be triggered when the recording disk is
80% full).
4. Check Disk Erro
r Alarm to enable Disk Error Alarms.
5. Click OK
.
6.8.2 Motion Alarm
The Motion alarm page allows you to configure camera motion detection
alarm settings. You must enable motion detection to use local (e.g. microSD/
SD card or FTP recording) motion detection recording. For instructions on
setting up local recording, see “6.9 Local Record” on page 37. For details on
motion recording using Syncro-V, see the Syncro-V manual on CD.
To configure motion detection:
1. Click Alarm
Configuration>Motion Alarm.
2. Check Enable under
Motion Parameter.
To Next Page
Loading...
