427-0030-00-28 Version 110 Jun 2013 1-4
1
Nexus IP Camera Configuration
1.4 System Information Displayed at Startup
When the camera is turned on, the video temporarily displays system information including the
camera serial number, the IP address, and, on a camera with a serial interface, the serial
communications parameters, such as the protocol (PelcoD or Bosch), the address, baud rate, and
setting of the serial control DIP switch: SW - software control (the default) or HW - hardware.
S/N: 1234567
IP Addr: 192.168.250.116
PelcoD (Addr:1): 9600 SW
1.5 FLIR Certified Systems Integrator (FCSI) Training
This configuration guide provides a brief description of the configuration parameters that are available
through the “basic” user login. For installers and integrators that are interested in a more advanced
level of configuration, the FLIR Certified Systems Integrator (FCSI) certification program offers hands-
on training with a variety of FLIR cameras, and focuses on integration design and installation with
other third-party security sensors and equipment. For more information, contact your local FLIR
representative or visit one of the following web sites:
http://support.flir.com/
http://www.flir.com/training
To Next Page
Loading...
