3 – Getting Started
12 Oct 2010 427-0026-01-10, version 110
Step 1 Drill holes for the six studs and cut an access hole for
mounting the Joystick Control Unit per the installation
template provided in paragraph 7.2 “Joystick Control Unit
Mounting Template.” on page 25. A sketch is shown in
Figure 3-5.
Step 2 Connect the JCU cable from the camera to the Primary
connector on the back of the JCU. See Figure 3-6.
Figure 3-5: Joystick Control Unit mounting template
This drawing is not to scale
DRILL 6.4mm (0.25”) for
(5.50”)
(5.20”)
threaded stud six places
CUT for JCU
(1.25”)
31.75mm
132mm
139.7mm
(1.25”)
31.75mm
60.325mm
(2.375”)
34.3mm
(1.35”)
Figure 3-6: Joystick Control Unit Power and Control
Power/control
to camera
Power/control
to optional
secondary JCU
Power from
fuse panel
ground wire
To Next Page
Loading...
