427-0075-01-12 Revision 140 October 2019 37
This document does not contain any export-controlled information.
Basic Operation and Configuration
Server > Services > Date and Time
The date, time, and time zone can be obtained from an NTP server, or can be entered manually. If
the NTP mode is selected, the NTP server information can be entered. The NTP server address can
be entered as a static address or can be obtained via DHCP.
Note
Set the date and time parameters, then select the Save button at the bottom. After saving the
settings, reboot the system. Refer to .
If the Custom mode is selected, a pop-up window allows the information to be entered manually.
The server must be stopped before date and time settings can be changed.
Select
Custom
Set Date
To Next Page
Loading...
