427-0075-01-12 Revision 140 October 2019 45
This document does not contain any export-controlled information.
Basic Operation and Configuration
Sensor > Communications > Serial Remote
Sensor > Communications > VMS Remote
The VMS Remote page provides communication interfaces for devices that connect to the camera.
Authentication when enabled uses the same passwords set from the Server Security Options
page. Refer to .
Nexus CGI Interface
After the interface is configured, scroll down and click on the Save button to save the configuration.
The changes will not take effect until the server is stopped and started.
Save
Select
protocol
Toggle Server (Stop/Start)
Pelco-D
settings
Bosch
settings
For ONVIF,
use the settings
in Interface 1
Scroll down
For Nexus CGI,
use the settings
in Interface 0
To Next Page
Loading...
Need help?
General
