Camera parts
5
The front side of the camera consists of a video image sensor (1) and the mi-
crophone array (2). The video shown on the display is monochromatic (black
and white) and the acoustic image is colored.
The camera has a resistive touch screen (3). The screen can also be used
with gloves. Only touch the screen using your finger - do not use the touch
screen with anything sharp or with hard objects, which may damage the sur-
face. Do not exert excessive force when pressing the screen as it will affect
the durability of the touch screen.
The main power source is an external battery which is connected to the bot-
tom of the handle (4). The camera comes with a battery cable (5) which can
be attached to the camera. Only use batteries and cables provided with the
camera or otherwise approved for use with the camera.
The status of the internal power supply unit is indicated by the power LED (6),
which is red when the power is on. While the power is on the camera dissi-
pates heat through the three heatsinks (8, 9, 10) which are located on both
sides and the top. While using the camera the heatsinks must be uncovered
to ensure that the heat dissipation works properly. Do not bag the device while
the Power LED is on. Please note that the heatsinks sometimes get hot after
prolonged usage, so be careful when touching the heatsinks.
There are two ways to export the results from the camera - using the included
FLIR Acoustic Camera Viewer service which requires a secure wifi connec-
tion, or through USB export (if available on your unit). The USB port is located
under the cover on top of the device (7). Please use the included USB memo-
ry stick for result export.
Note Protect the camera lens and the microphone array from any kind of
foreign objects, dust, and liquids.
#T810536; r. AB/63437/63437; en-US
7
To Next Page
Loading...
