User interface
8
The record time is by default 2 seconds and can be selected by the user.
When pressing the snapshot button, the previous 2 seconds of the sound
from the strongest source will be saved. This means, that if you are observing
a sporadic event, you can press the snapshot button immediately after you
have observed it. This also means that it is recommended to keep the camera
stable for a few seconds before taking a snapshot in order to get a clear signal
from the source of interest.
When taking a snapshot, a keyboard will be displayed, which you can use to
enter optional comments about the snapshot. After entering comments, press
the button in the upper right corner to save the comments and the snapshot. If
you at this stage choose not to save the snapshot, press the garbage bin but-
ton in the upper left corner instead.
8.3 Snapshot browser
The number of snapshots currently saved on the camera is shown to the right
of the snapshot browser button. If there are two dots visible next to the num-
ber, snapshots are currently being uploaded to the FLIR Acoustic Camera
Viewer.
Press the button to browse through the snapshots. On the bottom of the
screen, thumbnails of the snapshots are shown, and you can scroll through
these horizontally. When you press a thumbnail, the snapshot will be shown
together with additional information.
Note Note that snapshots are not available in the snapshot browser after
they have been uploaded to the FLIR Acoustic Camera Viewer service or ex-
ported to a USB memory stick.
#T810536; r. AB/63437/63437; en-US
14
To Next Page
Loading...
