User interface
8
Location color mode Strength color mode
The location color mode shows each sound source with several different col-
ors, ranging from blue to red. The center of the sound sources is shown with
red color, while the color gradually changes via yellow, green, and cyan to
blue outwards from the center of the sound source. The location color mode
is active in the Power application mode.
The strength color mode shows each sound source with a single color accord-
ing to the intensity of the sound source. The strength color mode is active in
the Air application mode. (Exception: When the SLM filter is enabled in Air ap-
plication mode, the location color mode is active.)
In addition to the heatmap, the location of the strongest sound source is
shown with a small crosshair. When taking a snapshot, the sound arriving
from the direction of the crosshair will be recorded. Application-specific real-
time analysis will also use the sound arriving from the direction of the
crosshair.
8.2 Take snapshot
Press the snapshot button to take a snapshot containing the current camera
image and heatmap as well as a short recording of the strongest sound
source. The direction of the strongest sound source is shown with a crosshair.
#T810536; r. AB/63437/63437; en-US
13
To Next Page
Loading...
