User interface
8
Poor wifi connection strength.
No wifi connection.
8.7.2 Change modes
Press the Change mode button to select the application mode; Air or Power.
8.7.3 Advanced settings
Press the Advanced settings button to access parameter settings for real-time
analysis calculations, such as leak size and cost estimation.
8.8 Filter
Press the filter button to switch between different filters. The available filters
depends on the selected application mode. The filters typically change the
frequency range that the camera uses for showing sound sources. The same
frequency range is also used when taking a snapshot and the sound is
recorded.
Try the different available filter settings to see which filter serves your applica-
tion best. Remember that the most appropriate filter might vary from case to
case, and depend not only on the sound source of interest, but also on the
background noise. For more information on choosing filters, see section 9.2
Locating sound sources and taking snapshots.
#T810536; r. AB/63437/63437; en-US
17
To Next Page
Loading...
