Handling the camera
13
13.1 Charging the battery
Note You must charge the battery for 4 hours before you start using the camera for the
first time.
13.1.1 General
You must charge the battery when a low battery voltage warning is displayed on the
screen.
Follow one of these procedures to charge the battery:
• Use the combined power supply and battery charger to charge the battery when it is in-
side the camera.
• Use the combined power supply and battery charger to charge the battery when it is
outside the camera.
• Use the stand-alone battery charger to charge the battery.
13.1.2 Using the combined power supply and battery charger to charge the
battery when it is inside the camera
Note For brevity, the ‘combined power supply and battery charger’ is called the ‘power
supply’ below.
13.1.2.1 Procedure
Follow this procedure:
1. Open the battery compartment cover.
2. Connect the power supply cable plug to the connector on the battery.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the green light of the battery condition
indicator is continuous.
See also:
For information about the battery condition indicator, see 8.4 Battery condition indicator,
page 17.
13.1.3 Using the combined power supply and battery charger to charge the
battery when it is outside the camera
Note For brevity, the ‘combined power supply and battery charger’ is called the ‘power
supply’ below.
13.1.3.1 Procedure
Follow this procedure:
1. Put the battery on a flat surface.
2. Connect the power supply cable plug to the connector on the battery.
3. Connect the power supply mains-electricity plug to a mains socket.
4. Disconnect the power supply cable plug when the green light of the battery condition
indicator is continuous.
See also:
For information about the battery condition indicator, see 8.4 Battery condition indicator,
page 17.
#T559879; r. AO/35410/35410; en-US
23
To Next Page
Loading...
