STRADA GENERATION3 - S5 - INSTALLATION MANUAL
3/66
TABLE OF CONTENTS
1. About this document .................................................................................................. 4
2. Security ....................................................................................................................... 5
3. Presentation of the equipment .................................................................................. 8
3.1 General presentation ............................................................................................. 8
3.2 Terminal dimensions and weight ........................................................................... 9
3.3 Presentation of the Main board ............................................................................ 11
4. Tools .......................................................................................................................... 12
5. Transport, Handling and Storage ............................................................................ 16
5.1 Recommendations on the transport and handling of the terminals ...................... 16
5.2 Handling a terminal removed from the transport pallet ........................................ 16
6. Floor preparation ...................................................................................................... 17
6.1 Floor space requirements .................................................................................... 17
6.2 Anchoring on flat ground ..................................................................................... 18
6.3 In-hole Anchoring ................................................................................................ 31
7. Installation of the equipment ................................................................................... 43
7.1 Removing the terminal from its transport pallet ................................................... 43
7.2 Opening the doors with a separate mechanical lock ........................................... 43
7.3 Opening the lower door with a dual mechanical lock ........................................... 44
7.4 Opening the upper door with a dual mechanical lock .......................................... 45
7.5 Opening the upper door with an electronic lock ................................................... 46
7.6 Removing the terminal from the pallet ................................................................. 48
7.7 Installing the equipment ....................................................................................... 49
7.8 Installing internal components ............................................................................. 56
8. Configuration of the equipment .............................................................................. 64
8.1 Power ON/OFF .................................................................................................... 64
8.2 Communication test ............................................................................................. 64
8.3 Program loading .................................................................................................. 65
8.4 Changing the settings of the terminal .................................................................. 65
To Next Page
Loading...