STRADA GENERATION3 – S5 - INSTALLATION MANUAL
6/66
Canada
The product is compliant with the following requirements:
RSS-Gen – General Requirements for Compliance of Radio communication equipment.
NMB-003 Information technology equipment, including digital equipment - Limits and methods of
measurement.
United States of America
This product is compliant with:
The National Electrical Code
The Americans with Disabilities Act (ADA)
The Federal Communication Commission (FCC) rules part 15
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
Electricity
All product-servicing operations require appropriate training.
Only adequately trained personnel may work on the mains power supply.
Protect personnel from electrical shocks with the help of appropriate electrical and earth
connections.
Always switch off the power before beginning some repairs, as instructed in this manual.
Make sure that the electrical parts are installed in accordance with national standards.
Keep the mains power supply disconnected throughout these operations. Protect the electrical
wires from the rain. Never work on products connected to the mains or the telephone network
during stormy weather.
While repairing a circuit breaker installed on a machine, the main circuit breaker located in the
technical unit must be switched off and marked with maintenance information so as to protect
the agent from electric shocks.
Isolate the mains power supply with the circuit breaker and switch off the low-voltage power with
the On/Off button on the main board.
Make sure that the earth cable is in good condition.
Follow the instructions relating to the earth connections of product components in order to ensure
compliance with EMC immunity and emissions standards.
The earth conductor that protects the power cord must be yellow and green.
Section of mains delivery cable: maximum 4mm2 for flexible cable and 6mm2 for rigid cable
Depending on the country of installation, the device may be connected to a 230V single-phase IT
network.
Ask for a signed certificate from the contractor.
For terminals installed outside and mains powered, some transient currents could occur. In
conformity with IEC61643 standard, customers must install surges arresters in order to prevent
this transient on their main circuit breaker.
To Next Page
Loading...