INSTALLATION INSTRUCTIONS
17
B
C
A
3.2 Unpacking
■ The materials (cardboard) used for packing the appliance are fully recyclable.
■ It is recommended that the packing material is only removed prior to installing the water heater. The
manufacturer will not be held responsible for damage caused by incorrect storage of the product.
■ Packing materials (plastic bags, polystyrene, nails, etc.) must not be left within reach of children, in that
these items represent a potential hazard.
A. Place the packed
appliance on the floor (see fig.
1) making sure that the "up”
arrow is facing down. Remove
the staples and open out the
four flaps of the box.
B. Rotate the water heater 90°
while manually supporting it
from underneath
C. Lift the box and remove the
protections. Lift the water
heater by grasping the rear
part and proceed with the
installation.
STORAGE & HANDLING
Please note that prior to
installation the FLOWMAX
water heaters should be
stored in the horizontal
position with no more than
three water heaters to a stack;
Ensure that the water heaters
are stored in dry conditions
and be aware that the carton is
a two-man lift;
Fig. 1
To Next Page
Loading...