10
First Time Setup
Step Seven:
Connecting the RCA Cable
Step Eight:
Playing a Record
The included RCA cable has a ground cable attached. When using the internal
preamp the ground cable is not required. Connect the RCA cables to the audio
outputs on the back of the turntable and then plug the other end into your stereo.
Optional: When using an external preamp the ground cable should be connected to the ground terminal on the back of the
turntable and also connected to the external preamp. Connect the RCA cables to the audio outputs on the back of the turntable
and then plug the other end into your preamp.
Tip: For best audio performance the dust cover should be removed during playback.
The turntable setup is now complete! Enjoy your Fluance turntable. Should you
require any further assistance please contact us at: www.uance.com/support
Note: When the turntable is not in use the speed selection knob should be set to OFF
to turn the turntable completely off.
Ground Cable (Optional)
1. Lift the dust cover
2. Place a record on the spindle
(use the 45 Adapter if necessary)
3. Turn the speed selection knob to
the correct RPM typically listed on
your record (Normal LP playback
speed is 33 RPM)
4. Unlock the tonearm lock
5. Lift the cueing lever
6. Move the tonearm to the desired
starting point
7. Lower the cueing lever
To Next Page
Loading...
