12
Maintenance
Cleaning the Unit
Replacing the Stylus
Replacing the Rubber Belt
Cartridge Connections
1. Use a soft dry cloth to wipe dust from the turntable surface.
2. Keep the dust cover closed to ensure the turntable components remain dust free.
Use the chart below to ensure you replace your stylus with the correct model.
Replacement stylus and instructions are available at Fluance.com
1. Remove the defective rubber belt
from the motor pulley.
2. Lift and remove the platter from the
spindle. Remove and discard the
defective rubber belt.
3. Wrap the new rubber belt around
the inner ring on the underside of the
platter and ensure the rubber belt is
not twisted.
ATN95E
Model Stylus
RT80 ATN91
RT81 ATN95E
Wire Channel
White Left (+)
Blue Left (-)
Red Right (+)
Green Right (-)
ATN91
4. Place the platter on the spindle and
turn it until the motor pulley is visible.
5. Lift the rubber belt and place it over
the motor pulley.
6. Rotate the turntable several times to
ensure the rubber belt is secure and
not twisted.
Note: See images in Step One of the First Time Setup instructions.
To Next Page
Loading...
