6
First Time Setup
Step One:
Installing the Platter
1. Remove the protective packaging
and ensure the turntable is placed
on a sturdy and level surface. Place
the metal platter onto the spindle
located in the middle of the turntable.
2. Rotate the platter until the rubber belt
installation ribbon aligns with the motor
pulley. Remove the tape from the
installation ribbon.
3. Use the installation ribbon to lift the
rubber belt and place it around the
motor pulley. Remove the installation
ribbon and rotate the platter several
times to ensure the rubber belt
is secure and not twisted.
4. Place the turntable mat on top of
the platter.
Note: If using the Fluance rubber turntable
mat ensure the Fluance logo is facing up
when placing the mat.
Turntable Mat
Metal Platter Installation Ribbon
Motor Pulley
Spindle
To Next Page
Loading...
