Fluke Biomedical ProSim 2 - Introduction; Safety Information

1
Introduction
 Warning
To prevent possible electrical shock, fire, or
personal injury, read all safety information
before you use the Product.
The ProSim™ 2 and ProSim™ 3 Vital Signs Simulators
(the Product) are electronic signal sources used to
measure the performance of patient monitors. The Product
simulates:
• ECG (with and without arrhythmias)
• Respiration
• Blood pressure
• Temperature
• Cardiac output (ProSim 3 only)
• Fetal/Maternal ECG and IUP (ProSim 3 only)
The ProSim™ 3 is shown in all illustrations.
Safety Information
A Warning identifies conditions and procedures that are
dangerous to the user. A Caution identifies conditions and
procedures that can cause damage to the Product or the
equipment under test.
Table 1 is a list of symbols used on the Product and in this
manual.
 Warning
To prevent possible electrical shock, fire, or
personal injury:
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
• Do not connect the Product to a patient or
equipment connected to a patient. The
Product is intended for equipment analysis
only. Do not use the Product for
diagnostics, treatment, or other capacity
where the Product touches a patient.
• Remove the batteries if the Product is not
used for an extended period of time, or if
stored in temperatures above 50 °C. If the
batteries are not removed, battery leakage
can damage the Product.
• Replace the batteries when the low battery
indicator shows to prevent incorrect
measurements.