Fluke Biomedical ProSim 2 - Maintenance; General Maintenance

Vital Signs Simulator
Maintenance
41
Maintenance
 Warning
To prevent possible electrical shock, fire, or
personal injury:
• Have an approved technician repair the
Product.
• Use only specified replacement parts.
• Remove the input signals before you clean
the Product.
• Batteries contain hazardous chemicals that
can cause burns or explode. If exposure to
chemicals occurs, clean with water and get
medical aid.
• Do not put battery cells and battery packs
near heat or fire. Do not put in sunlight.
• Do not disassemble the battery.
• Remove batteries to prevent battery
leakage and damage to the Product if it is
not used for an extended period.
• Do not short the battery terminals together.
For safe operation and maintenance of the
Product:
• Keep cells and battery packs clean and
dry. Clean dirty connectors with a dry,
clean cloth.
• Repair the Product before use if the battery
leaks.
• Be sure that the battery polarity is correct
to prevent battery leakage.
• Do not keep cells or batteries in a
container where the terminals can be
shorted.
• Do not disassemble or crush battery cells
and battery packs.
General Maintenance
Clean the case with a damp cloth and weak detergent. Do
not use solvent or cleaners with abrasives.
 Warning
For safe operation and maintenance of the
Product:
• Do not put fluid on the Product surface.
Fluid leakage into the electrical circuitry
can cause the Product to fail.
• Do not use spray cleaners on the Product.
This can push fluid into the Product and
cause electronic component damage.