1520
Calibration Manual
2
Contacting Fluke
To order accessories, receive assistance, or locate the nearest Fluke distributor or Service
Center, call:
USA: 1-888-99-FLUKE (1-888-993-5853)
Canada: 1-800-36-FLUKE (1-800-363-5853)
Europe: +31 402-678-200
Japan: +81-3-3434-0181
Singapore: +65-738-5655
Anywhere in the world: +1-425-446-5500
Address correspondence to:
Fluke Corporation Fluke Europe B.V.
P.O. Box 9090, P.O. Box 1186,
Everett, WA 98206-9090 5602 BD Eindhoven
USA The Netherlands
Visit us on the World Wide Web at: www.fluke.com
Precautions and Safety Information
WWarning
If this product is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired.
Read the “Safety Information” page before servicing this product.
In this manual, a Warning identifies conditions and actions that pose hazard(s) to the
user; a Caution identifies conditions and actions that may damage the Meter or the test
instruments.
International Symbols
International symbols used on the Meter and in this manual are explained in Table 1.
Table 1. International Symbols
Risk of electric shock
J
Earth
See manual
I
Fuse
Equipment protected by double or reinforced
insulation
D
AC or DC
Battery Recycling information
Conforms to CSA C22.2 No 1010.1-92 + Amendment
2 1997, UL 3111 and ANSI/ISA SP82.01 1994
VDE
Conforms to VDE EN61010
(Pending)
Conforms to EU directives t Conforms to UL 3111.1
CAT
III
OVERVOLTAGE (Installation) CATEGORY III, Pollution Degree 2 per IEC1010-1 refers to the level of
Impulse Withstand Voltage protection provided. Equipment of OVERVOLTAGE CATEGORY III is equipment
in fixed installations (e.g., electricity meter and primary over-current protection equipment.
To Next Page
Loading...
Need help?
General
