Enter button to continue initialization. If an error message is displayed on
power up see Section 11.1, Troubleshooting.
4.7 Measure Temperature
After initialization, the temperature measurements for the configured channels
are displayed. The appropriate sensor type must be selected and coefficients en
-
tered for the measurements to be accurate (see Section 7.2.1, Edit Probe). Place
the sensors of the probe into the object(s) you want to measure. DO NOT force
the probe(s) or otherwise allow them to be bent, stressed, or overheated. Probes
can be easily damaged if misused. For further suggestions on handling the
probe and using the 1529 and probe to measure temperature accurately, see
Section 6, General Operation. For information on the various modes of opera
-
tion of the 1529 see Section 7, Display Functions.
13
4 Quick Start
Measure Temperature
To Next Page
Loading...
