Fluke 1625 User Manual

1625
Users Manual
28
Control Loop
After turning the function rotary switch, the voltage display mode is reached.
Pushing "DISPLAY MENU" now calls up the control loop. According to the
selected measuring function, different setting values can be displayed and
changed in the control loop. The "DISPLAY MENU" button switches between
the different set values inside a contiuous loop. The "SELECT" button selects
the decimal point to be changed. Pushing the "CHANGE ITEM" button the
instrument either switches between certain set values or increases the decimal
point selected with "SELECT" by 1.
After parmeter setting has been finished the next display can be called with
"DISPLAY MENU" or the measurement can be started with "START TEST".
Depending on the selected function, the following parameters can be displayed
or changed:
Function Parameter Setting Range Remarks
U
ST
display only
F
ST
display only
R
E
3pole
F
M
(AFC/94/105/111/128) Hz
U
M
48 V/20 V selectable to 20 V
with CODE
and R
K
0.000 Ω ... 29.99 Ω in position R
E
3pole only *
R
E
LIMIT 0.000 Ω ... 999 kΩ only if activated
with CODE
R
E
4pole
}(warning On/Off only if R
E
LIMIT
Sound) is activated with
CODE
R* On/Off only if activated
with CODE
U
ST
display only R
E
F
ST
display only

Fluke 1625 Specifications

General

Storage Temperature	-20 °C to 60 °C
Testing Methods	3-pole fall-of-potential, 4-pole
Measurement Frequency	128 Hz
Power Supply	6 x 1.5 V AA batteries or optional AC adapter
Safety Rating	CAT II 300 V
Safety Standards	IEC 61010-1