Options and Accessories
GPS-Time Synchronization Module Option 6
6-27
GPS-Time Synchronization Module Option
This option consists of a GPS-receiver module including GPS antenna, and a 5 m
connection cable for the Instrument 25-pole feature connector (on top of the instrument).
Note
For optimal performance the GPS receiver should be placed in a location
where at least 4 satellites are within the receiving are; concrete, metal
construction elements and roofs may interfere with, and reduce the GPS
signal level. An extension cable with 10 m length is available to enable
positioning of the receiver in clear sight.
Technical Specification
Dimensions: Diameter 61 mm (2.4 inch).
Height: 19.5 mm (0.77 inch).
Weight: Appr. 200 g. (0.4 lbs)
Cable length: 5 m. (16.5 ft)
Mounting: Integrated magnetic base.
Case: Polycarbonate thermoplastic.
Protection: IPX7 as per IEC 60529.
Operating temp. range: −30 °C - +80 °C.
Storage temp. range: −40 °C - +90 °C.
Power consumption: 0.3 W typ.
Sensitivity: −165 dBW.
Acquisition time: Cold start: 45 s.
Warm start: 15 s.
Re-acquisition: 2 s.
Protocol: NMEA 0183 V2.0, or V2.30.
UTC (Coordinated Universal Time).
PPS (pulse per second), rising edge.
Satellites: Tracking of up to 12 satellites continuously.
Time accuracy: Better than ±1 μs at rising edge of pulse.
Memory: Non volatile memory for storage of configuration data.
Part Number: 2539223
Procedure:
1. Run the PQ Analyze software and open menu Service – GPS Configuration.
To Next Page
Loading...
Need help?
General