2352 Walsh Ave. Santa Clara, CA 95051. U. S. A. Tel.: (408) 748-9100, Fax: (408) 748-9111 www.analogtechnologies.com
Copyrights 2000 – 2012, Analog Technologies, Inc. All Rights Reserved. Updated on 11/22/2012 11
nalog Technologies
317 and 319
Clamp Meter
AUTO POWER OFF
The clamp meter turns of if there is no button pushed or rotary function switch operation for 20 minutes. Turn the clamp meter
off and on to restart the clamp meter. This feature is disabled in MIN, MAX and HOLD modes; it can also be disabled for all
modes by holding
while turning the clamp meter on.
MAINTENANCE
Warning
To avoid electrical shock, or personal injury:
Repairs or servicing not covered in this datasheet should be performed only by qualified personnel.
Disconnect test leads from the clamp meter before removing its back cover.
Never use the clamp meter with back cover removed.
Caution
If the clamp meter is not going to be used for an extended time, remove the batteries. Do not store the clamp meter in
high temperature or high humidity environments.
CHANGING BATTERIES
When battery voltage drops below the value required for proper operation, the battery symbol (
) appears. Although the clamp
meter continues to work correctly, the batteries should be replaced as soon as possible. As the battery voltage drops below the
low limit, the clamp meter will shut down.
To change batteries:
1. Turn the clamp meter off and disconnect the test leads.
2. Using a screwdriver, open the battery cover on the bottom of the clamp meter.
3. Replace the batteries with three new AAA IEC LR03 batteries.
4. Close the back cover and tighten the screw.
CLEANING THE CLAMP METER
Caution
To avoid damaging the clamp meter, do not use abrasives or solvents on this instrument.
Periodically clean the clamp meter by wiping it with a damp cloth, mild soap may be used.
ORDERING INFORMATION
Table 7. Unit Price
Part# Unit Price
317 $166.07
319 $211.19
NOTICE
1. ATI reserves the right to make changes to its products or to discontinue any product or service without notice, and advise
customers to obtain the latest version of relevant information to verify, before placing orders, that information being relied on is
current and complete.
2. All products are sold subject to the terms and conditions of sale supplied at the time of order acknowledgment, including
those pertaining to warranty, patent infringement, and limitation of liability. Testing and other quality control techniques are
utilized to the extent ATI deems necessary to support this warranty. Specific testing of all parameters of each device is not
necessarily performed, except those mandated by government requirements.
To Next Page
Loading...
