Fluke 41B - Page 27

Keypad
17
Table 1. Key Descriptions (cont)
Number Symbol Name & Description
8
f
Phase Reference
Press to select volts or amps as the display
phase reference. Voltage reference is the
standard configuration. For current only
measurements, press
f to set AP . To
change the power-up phase reference, see
“Power-Up Configuration” later in this manual.
9
s
Send (Model 41B)
Press to print a test report of calculated
measurements to a printer or PC. (The Tester
displays SEND.) Do not press
s when
FlukeView 41 application software is in use. See
“Sending to a PC”.
10
S
Smooth
Smooth allows you to average waveforms,
resulting in a more stable screen and increased
accuracy of computations. (See “Specifications.”)
Press
S four times to step through the
Smooth selections (
~ 2s, ~ 5s, ~ 10s,
~ 20s in the top status line). Pressing S a
fifth time returns the Tester to normal operation.