Maintenance
Fault Codes
4
4-19
1302 Output Tripped To Standby
1303 DC Zero Calibration is Needed (Every 30 Days)
1400-Level Faults: Software Timer Subsystem
1400 Cannot Install MTtick()
1401 Bad Timer Selector
1500-Level Faults: Guard Crossing Receive Subsystem
1500 Could not ACK Packet From Inguard
1501 Illegal Inguard Receive Task State
1502 Bad Receive Packet Number From Inguard
1503 Bad Control Byte From Inguard
1600-Level Faults: Guard Crossing Transmit Subsystem
1600 Multiple Timeouts Sending To Inguard
1601 Inguard Request Reset Loop
1602 Unexpected NSA From Inguard
1603 Bad Packet Number In ACK From Inguard
1604 Bad Control Byte From Inguard Rcv Task
1605 Illegal Inguard Transmit Task State
1606 Inguard Indefinite ACKWAIT Holdoff
1700-Level Faults: Guard Crossing Utility Subsystem
1700 Serial Write Failure To Inguard
1701 Packet Too Large For Inguard
1800-Level Faults: Normal Output Operations Subsystem
1800 DORMANT To OPERATE
1801 Bad Transition Type
1802 Bad Boolean Selector
1803 NRMrngStby Encountered Error
1804 DCV Called For Non-DCV Range
1805 ACV Called For Non-ACV Range
1806 Bad ACV Frequency Range
1807 Hi Res Frequency Too High
1808 ACV Amplitude Correction Failure
1809 Cannot Phase Lock To Signal
1810 Bad Phase Quadrant
1811 Current Called for Non-Current Range
To Next Page
Loading...
