5700A/5720A Series II Calibrator
Service Manual
4-20
1812 Ohms Called for Non-Ohms Range
1813 Cannot Phase Lock, Output Not AC
1814 Cannot Phase Shift, Output Not AC
1815 Bad Wide Band Range
1816 Freq. Too High Even For Wide Band
1817 Illegal Current Output Location
1818 Output Current Out Of Tolerance
1819 Current Compliance Voltage Exceeded
1820 2-Wire Compensation Current Exceeded
1821 NRMbstcur Passed Bad Range
1822 5220 No Longer Connected
1823 5220 Detected Fault And Shut Off
1824 5205 No Longer Connected
1825 5205 Detected Fault And Shut Off
1826 5725 No Longer Connected
1827 14 Bit DAC Scaling Found Zero Output
1900-Level Faults: Non-Volatile Subsystem
1900 Could not Write Byte To EEPROM
1901 Checksum Error Reading EEPROM
1902 EEPROM Is Full
1903 Unknown Nonvolatile Constant Selector
1904 EEPROM Partition Is Full
1905 Could not Write Byte To 5725 EEPROM
1906 Checksum Error Reading 5725 EEPROM
To Next Page
Loading...
