Fluke 6109A - Run a Program

Portable Calibration Baths
Operation
29
The extension “.txt” is automatically appended to the filename when the file is
created. If the file already exists, new data is appended to the end of the file. The
file is placed in a folder determined by the serial number of the Product:
\Fluke\7109_6109\<product serial number>\Data\
Each line in the file contains the date and time, fluid temperature, its unit of
measurement, reference probe reading, its unit of measurement, DUT reading,
and its unit of measurement. Fields are separated by commas. If reference probe
or DUT readings are not available, the field is empty.
Run a Program
A program instructs the Product to step through a sequence of setpoints to
automatically test sensors at multiple temperatures.
To set up a program:
1. Push .
2. Push  (New).
3. Push  to specify the program name. See Keyboard Use.
4. Push  (Save) to save the program name.
5. Push  (Edit Setpoints) to specify the setpoints.
6. Push  or  to choose an existing setpoint or  to add a new setpoint.
7. Push  to edit the setpoint temperature.
8. Use the number keys to type the setpoint temperature.
9. Push  to save the setpoint.
10. Push  after all setpoints have been defined.
11. Push  several times to move the highlight to Dwell Time.
12. Push  to edit the Dwell Time.
13. Use the number keys to type in a time in minutes.
14. Push  to save the value.
15. Push  (Save) to save the program.
If the Input Module (7109A-P or 6109A-P) is installed, the module can collect the
sensor readings and produce a test report. To turn on program report:
1. Push .
2. Push  or  to choose a program.
3. Push  (SELECT).
4. Push  (Options).
5. Push  to move the highlight to Program Report.
6. Push  to change Program Report to ON.
7. Push  to move to Pass Tolerance.
8. Push  to change the number.
9. Use the number keys to type in the new number.
10. Push  to save the value.
w ww . . co m
information@itm.com1.800.561.8187