6109A/7109A
Operators Manual
2
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the
Product or the equipment under test.
Warning
To prevent possible electrical shock, fire, or personal injury:
• Read all safety information before you use the Product.
• Do not keep the Product in operation and unattended at high
temperatures.
• Use the Product only as specified, or the protection
supplied by the Product can be compromised.
• Turn the Product off and remove the mains power cord.
Stop for two minutes to let the power assemblies discharge
before you open the fuse door.
• Replace a blown fuse with exact replacement only for
continued protection against arc flash.
• Use only specified replacement fuses.
• Use only specified replacement parts.
• Disconnect the mains power cord before you remove the
Product covers.
• Disable the Product if it is damaged.
• Do not use the Product if it is altered or damaged.
• Do not heat bath fluid above its flash point unless it is
necessary, approved, and handled safely. The bath fluid or
its vapor may be flammable.
• Connect an approved three-conductor mains power cord to
a grounded power outlet.
• Use this Product indoors only.
• Do not use a two-conductor mains power cord unless you
install a protective ground wire to the Product ground
terminal before you operate the Product. Make sure that the
Product is grounded before use.
• Do not touch parts of the Product that can be hot, including
the area around the tank, the bath fluid, the overflow tube,
overflow tank, and drain tube.
• Refer to the bath fluid and solvent’s safety data sheets
(SDS) as these may require additional safety precautions.
• Do not spill bath fluid on the floor. Spilled bath fluid creates
a safety hazard.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
