Fluke 6109A - Page 50

6109A/7109A
Operators Manual
46
*SRE <numeric_value>
*SRE?
Set bits in the IEEE-488.2 Service Request Enable Register.
<numeric_value> is a decimal number that range from 0 to 255. This determines
which bits of the Status Byte Register affect the MSS bit of the Status Byte
Register.
*STB?
Return the IEEE-488.2 Status Byte Register.
The response is a decimal number that range from 0 to 255. The definitions of
the bits are shown in Table 6.
Table 6. *STB Bits
Bit Name Definitions
0 — not used
1 — not used
2 ERR Error message flag
3 QSB Questionable status flag
4 MAV Message available (not used)
5 ESB Standard Event Status flag
6 MSS Master summary status
7 OSB Operation status flag
*TST?
Return the self-test results.
The response is 1 if a failure was detected or 0 otherwise.
*WAI
Wait to continue. Since all commands are sequential, this command is not
necessary for synchronization.
CALibration:DATE <year>,<month>,<day>
CALibration:DATE?
Store the given date as the Product calibration date.
This command is password protected.
CALibration:DATE:MODule <year>,<month>,<day>
CALibration:DATE:MODule?
(-P models only) Store the given date as the calibration date of the Input Module.
This command is password protected.
w ww . . co m
information@itm.com1.800.561.8187