Fluke 6109A - Page 84

84 pages

Save Page as PDF

To Previous Page

To Previous Page

Loading...

6109A/7109A

Operators Manual

80

w ww . . co m

information@itm.com1.800.561.8187

Table of Contents

Table of Contents3
Introduction5
Contact Fluke Calibration5
Safety Information6
Symbols7
Specifications8
- Temperature Source Specifications8
- Input Module Option Specifications9
- General Specifications10
Unpack the Product11
Product Overview11
- Top11
- Front13
- Control Panel14
- Back15
- Input Module (Option)16
Installation16
- Product Placement16
- Provide Ventilation17
- Add Bath Fluid17
- Attach the Probe Access Cover18
- Connect to Mains Power18
- Attach Accessories20
Turn on the Product23
- Set the Language, Time, and Date23
- Set the Password24
Connect the Reference Probe and Test Sensor24
- Connect the Reference Probe24
- Configure the Reference Probe Coefficients26
- Connect a Test RTD26
- Configure the RTD Type27
- Connect a Thermocouple27
- Configure the Thermocouple Type28
- Connect a 4-20 Ma Transmitter28
- Configure the Ma Input28
Operation29
- Display29
- Basic Operations30
- Run a Program33
Menu Guide34
- Monitor34
- Setpoint35
- Program36
- Setup39
Remote Operation46
- Setup46
- USB Device46
- Test47
- Rs-23247
Commands48
- SCPI Conformance Information48
- Command Reference48
Maintenance69
- Clean the Product69
- Clean up Spills69
- Check the Bath Fluid70
- Drain the Bath Fluid70
- Transport the Calibration Bath71
Calibrate the Product71
- Temperature Setpoint Calibration72
- Temperature Stability Calibration73
- Temperature Uniformity Calibration74
- Input Module Calibration75
Troubleshooting78
Fluid Selection80
- Temperature Range80
- Safety80
- Viscosity81
- Heat Capacity81
- Thermal Expansion81
- Lifetime81
- Disposal82
- Silicone Fluids82
Customer-Replaceable Parts and Accessories83

Related product manuals

Preview: Fluke 6100B

Preview: Fluke 6200

Preview: Fluke 6270A

Preview: Fluke T6-600

Preview: Fluke T5-600

Preview: Fluke 6200-2

Preview: Fluke 705

Preview: Fluke 725