Fluke 683 - Page 35

Enterprise LANMeter
Setup/Utils
27
Figure 13 shows the Setup/Utils softkeys.
Figure 13. Setup/Utils Softkeys (Version 9.50)
Any configuration changes that you make are automatically saved to non-
volatile memory when you press
G
. You can undo configuration changes
before you press
G
by selecting
Cancel Changes
in the pop-up
Configuration Menu, and pressing
I
. Figure 14 shows a Configuration
Menu.
Figure 14. Configuration Pop-up Menu
You can use the factory defaults for the selected Setup/Utils category by
selecting
Restore Defaults
, and then pressing
I
from the Configuration
Menu (when available). The defaults are then saved to non-volatile memory
when you press
G
to exit the Setup/Utils category.
You can reset all Setup/Utils categories and test configurations by selecting
Reset All Configs, then pressing I from the Configuration Menu.
Resetting all configurations does not erase saved Station Lists.