Fluke 683 - Self-Test; Keyboard Test

Enterprise LANMeter
Setup/Utils
33
Self-Test
The first time you turn on your LANMeter instrument on a particular day, the
instrument automatically performs extensive power-on self tests. All
subsequent power-on self tests for that day are less extensive and completed in
much less time.
You can verify correct operation of the instrument manually by using the
following procedure:
1. Press the top-level
Setup/Utils
softkey.
2. Press
E
and then the
Self Test
softkey.
3. Select the appropriate self-test and press
I
.
You can run the following self-tests on the LANMeter instrument:
1. LANMeter Self Test
2. LANMeter Keyboard Test
3. LANMeter Serial Test
4. 100 MHz Cable Remote Test
Self Test
When running the LANMeter Self Test, disconnect all cables from the
instrument
TO MAU
and
TO NIC
connectors. Verify that all tests pass. The
instrument displays the message
Passed
for each test to indicate proper
operation. These self tests are more extensive than the power-on self tests.
If the instrument reports a failure, perform the steps in the “Service Center
Repair” section of Appendix C “Maintenance” of the Users Manual.
Keyboard Test
When running the LANMeter Keyboard Test, manually perform the steps
displayed on the screen and verify that the test passed. The five softkeys
shown in Figure 4 are referred to as F1 through F5 with F1 being the leftmost
softkey and F5 the rightmost.