Enterprise LANMeter
Attaching Cables
39
TO NIC Connection
Use the
TO NIC
connector for the NIC Autotest as shown in Figure 18.
EXIT
STOP
MORE
MENUTAB
ENTER
RUN
PRINT
HELP
ALPHA
SHIFT
ABC
789
456
123
0
•
SPACE
DEF
% UTILIZATION
HUB NIC
FRAME ERROR
BEACON
POLARITY
WIRE FAULT
LINK ACTIVE
INSERT
TRANSMIT
16 Mb/S
BNC
4 Mb/S
GHI
JKL
MNO
PQR
STU
VWYXZ
COLLISION
RING ERROR
686 ENTERPRISE LANMETER
10/100 ETHERNET
TOKEN RING
Figure 18. TO NIC Connection
For 100BASE-TX or 10BASE-T networks, connect the NIC card to the
instrument’s
TO NIC
connector. Refer to the section on the test that you are
going to run for additional connection information.
For ThinLAN coaxial networks, the instrument and the NIC under test must be
the only devices on the network. The connection should be a relatively short
coaxial cable (less than 20 feet) with a single terminator and T connector at the
network interface card. The instrument automatically terminates its end of the
cable for this test.
To Next Page
Loading...
