Enterprise LANMeter
Setup/Utils
29
r Connector Type as RJ-45, or BNC
r Ethernet Speed as Auto Detect, 10 Mbps, or 100 Mbps (for RJ-45 only
and on Fluke 686 and 683 instruments only)
r LANMeter MAC as Predefined or user definable
The Auto Detect Ethernet Speed selection puts the instrument in a mode where
it automatically detects the network speed and sets its configuration to match
that speed. If the instrument is configured for Auto Detect and is then
connected to an auto-speed port, it automatically negotiates for a speed of 100
Mbps.
The LANMeter MAC is the MAC address used by the instrument while it is
inserted in the network.
Token Ring
Caution
Selecting an incorrect ring speed will cause the ring to
beacon.
r Connector Type as DB-9, or RJ-45
r Ring Speed as Auto, 4 Mbps, or 16 Mbps
r LANMeter MAC as Predefined or user definable
r Beacon Detect as Enable or Disable
The Auto ring speed selection puts the instrument in a mode where it
automatically detects the network speed and sets its configuration to match that
speed. The Auto ring speed selection should not be used when using smart
MAUs such as the IBM Controlled Access Unit (CAU), Lobe Attachment
Modules, or the Madge SmartCAU.
The Beacon Detect field enables or disables the Beacon pop-up window to
appear when a beacon frame is detected.
To Next Page
Loading...
