EasyManuals Logo

Fluke 725/FPC User Manual

Fluke 725/FPC
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
725
Users Manual
50
Battery and
Compartment
Fuse
Compartment
sh38f.eps
Figure 23. Replacing the Battteries
Maintenance
Cleaning the Calibrator
W Warning
To avoid personal injury or damage to the
calibrator, use only the specified
replacement parts and do not allow water
into the case.
Caution
To avoid damaging the plastic lens and case,
do not use solvents or abrasive cleansers.
Clean the calibrator and pressure modules with a soft
cloth dampened with water or water and mild soap.
Service Center Calibration or Repair
Calibration, repairs, or servicing not covered in this
manual should be performed only by qualified service
personnel. If the calibrator fails, check the batteries first,
and replace them if needed.
Verify that the calibrator is being operated in accordance
with the instructions in this manual. If the calibrator is
faulty, send a description of the failure with the calibrator.
Pressure modules do not need to accompany the
calibrator unless the module is faulty also. Be sure to
1.800.561.8187information@ITM.com
Fluke-Direct.ca

Table of Contents

Other manuals for Fluke 725/FPC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke 725/FPC and is the answer not in the manual?

Fluke 725/FPC Specifications

General IconGeneral
BrandFluke
Model725/FPC
CategoryTest Equipment
LanguageEnglish

Related product manuals