Documenting Process Calibrators
Safety Information
3
• Connect the common test lead before the
live test lead and remove the live test lead
before the common test lead.
• Use only current probes, test leads, and
adapters supplied with the Product.
• Do not touch the probes to a voltage
source when the test leads are connected
to the current terminals.
• Use only cables with correct voltage
ratings.
• Do not use test leads if they are damaged.
Examine the test leads for damaged
insulation, exposed metal, or if the wear
indicator shows. Check test lead
continuity.
• Examine the case before you use the
Product. Look for cracks or missing
plastic. Carefully look at the insulation
around the terminals.
• Always put the stackable end of the test
lead into a terminal of the Product.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
