Documenting Process Calibrator
Date and Time
27
To set the time and date displays:
1. Push s.
2. Push the Next Page softkey. See Figure 9.
gks38s.bmp
Figure 9. Time and Date Display
3. Push and to move the cursor to the necessary
parameter, then push or the Choices softkey to
choose a setting for that parameter.
For example, the display in Figure 10 is shown after
you select Date Format.
gks39s.bmp
Figure 10. Edit the Date Format
4. Push or to move the cursor to the necessary date
format.
5. Push to select the format and go back to Setup
mode.
6. Choose a different selection or push the Done softkey
or s to save the settings and exit Setup mode.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca
To Next Page
Loading...
