Fluke 771 User Manual

Milliamp Process Clamp Meter
Symbols
3
• When measuring, keep fingers behind the Tactile Barrier.
See Figure 1.
• Not for use with non-insulated conductors.
WCaution
To avoid damage to the Meter, do not open the Meter for
cleaning. Do not use solvents to clean it, and do not immerse it
in liquid.
Symbols
Table 1 explains the symbols that are used on the Meter or in this manual.
Table 1. Symbols
-
Do not apply around, or remove from HAZARDOUS LIVE conductors
W
Risk of danger. Important information. See Users Manual.
X
Risk of Electrical Shock
T
Equipment protected by double or reinforced insulation
M
Battery
B
Low Battery
P
Conforms to relevant European Union directives
F
DC (Direct Current)
~
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s web site for
recycling information.
;
N10140
Conforms to relevant Australian standards
)
Conforms to relevant Canadian and US standards
CAT II
300 V
Equipment is designed to protect against transients in equipment in fixed-equipment
installations, such as distribution panels, feeders and short branch circuits, and lighting
systems in large buildings.
1.800.868.7495info@Fluke-Direct.ca
Fluke-Direct.ca

Fluke 771 Specifications

General

Operating altitude	0 - 2000 m
Storage temperature (T-T)	-25 - 60 °C
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	0 - 90 %
Product type	Digital multimeter
Product color	Grey, Red, Yellow
DC current range	0.021 - 0.1 A
Resolution (DC current)	0.21 µA
Basic accuracy (DC current)	1% + 5 counts
Battery type	AA
Power source	Battery
Battery voltage	1.5 V
Battery technology	Alkaline
Number of batteries supported	2

Weight and Dimensions

Depth	38 mm
Width	59 mm
Height	212 mm
Weight	260 g