787
Users Manual
30
Holster with
probe clip
Meter in holster face
down for protection
ee009f.eps
Figure 9. Using the Holster
Maintenance
This section provides some basic maintenance
procedures. Repair, calibration, servicing not covered in
this manual must be performed by qualified personnel. For
maintenance procedures not described in this manual,
contact a Fluke Service Center.
General Maintenance
Periodically wipe the case with a damp cloth and
detergent; do not use abrasives or solvents.
Calibration
Calibrate your Meter once a year to ensure that it performs
according to its specifications. Contact a Fluke Service
Center for instructions.
Replacing the Battery
! Warning
To prevent possible electrical shock, fire, or
personal injury:
• Remove test leads from the Meter before
opening the battery door.
• Make sure the battery door is closed and
latched before operating the Meter.
1.888.475.5235info@Fluke-Direct.com
Fluke-Direct.com
To Next Page
Loading...
