Fluke CableIQ - Additional Resources for Cable Testing Information; Knowledge Base Access; Unpacking the CableIQ Tester; Included Accessories

Testing for Continuity
11
Testing for Continuity
The continuity function lets you test for opens and shorts
on the 8-pin modular jack or the coaxial connector.
Turn the rotary switch to DIAG. Use
D to highlight
Continuity; then press
H, J, or P.
The tester’s beeper is silent for resistances above about
5000 Ω. The beeper’s tone and rhythm increase as
resistance decreases.
axy37