A
To ensure continuous operation, connect the ac adapter
whenever possible.
B
The LED lights when remaining battery life is about 30 minutes.
C
Screw an adapter tip onto the fiber probe to match the
connection you are inspecting. Use the universal tip for patch
cords. Use the connector-specific tips for bulkhead connectors.
D
Set the power mode:
•
OFF/CHARGE: Display is off. The battery charges when the ac
adapter/charger is connected.
•
ON: Display is always on.
•
GRIP: Display is on when you squeeze the grip triggers (
E
).
Use this mode to conserve battery power.
Note
Set the switch to OFF/CHARGE when not using the display.
If the switch is left in the GRIP position, the display may be
turned on unintentionally, draining the battery.
E
Grip triggers. See GRIP under
D
.
F
Turn the wheel to focus the image.
G
Used with the optional TPak
TM
kit to hang the display. May be
removed using the hex key included.
H
Battery door. See "Replacing the Battery".
Maintenance
Clean the LCD display with glass cleaner and a soft, lint-free cloth.
Clean the display and probe housings with a soft cloth dampened
with water or a mild detergent. Do not use solvents or abrasive
cleansers.
To Next Page
Loading...
