Fluke IDA-5 - How to Test Infusion Devices

IDA-5
Users Manual
10
How to Test Infusion Devices
When you test an infusion device, it is recommended that you record the details of the
device you are testing and the test parameters. From the Status All Channels screen,
select SETUP for the relevant channel. These examples use channel 1.
The Channel 1 Setup screen described in Table 4 is shown.
Table 4. Channel Setup Screen Controls
Channel 1 Setup
Device Information
Template
Occlusion
Flow
PCA/Dual Flow
Press ESC for Status Screen
gir06.eps
Control Description
Device Information Shows a screen that lets you record infusion device data and test details.
Template Shows a screen that lets you set a template to control a sequence of tests.
Occlusion Occlusion test without details.
Flow Flow test without details.
PCA/Dual Flow
PCA or dual flow test without details – asks for necessary PCA/dual flow
parameters.