Infusion Device Analyzer
Templates
23
Define a Template
To define a template:
1. From the Status All Channels screen, select ESC for Utilities.
2. Select Edit Templates.
3. On the Templates screen, select Add. The Template Detail screen is shown in Table
17.
4. Record the values shown in Table 17.
Table 17. Template Detail Screen
Template Detail
Name SYRINGE DEMO TEMPLATE
Comment Syringe pump quick check
Step Type
Flow
Rate
Unit
Time
hh:mm
1 FLOW 20 10 ml 00:30 5
2 FLOW 50 10 ml 5
3 OCCL 50 12 psi 00:05 0
4
5
6
Save Delete Step
Delete Template
Press ESC for Templates screen
Vol Pres
Tol%
gir21.eps
Field Description
Name Record a name for your template.
Comment More data can be recorded here.
Step 1
Type
Use the down arrow to set the Type of test from the list (“FLOW” in this case).
Note
The Unit field is ml. ml is the only applicable unit for a flow step.
Rate Record the flow rate (20 for this example).
Vol/Press Record the volume/pressure which will be used for the test (10 for this example).
Unit Push ENTER to accept ml.
Time Record the maximum time for the test (00:30 for this example).
Tol%
Initially, this field holds the default value from the Test Preferences screen.
Note
The tolerance value is ignored for occlusion tests.
To Next Page
Loading...
