Fluke LinkIQ - Do a Cable Test

Cable+Network Tester
Cable Tests
17
Do a Cable Test
Cable tests pass or fail based on the settings selected for the test. To pass a test:
 The Product must detect a Remote ID.
 The wire map must match the selected wire map settings.
 The cable under test must meet or exceed the selected test limit.
To d o a ca bl e te s t :
1. Turn on the Product.
2. If necessary, adjust the settings. See Settings Menu.
3. Connect one end of the CAT6A copper patch cable or other approved cable into the RJ-45
jack on the Product. See Figure 2.
Figure 2. Cable Test Set Up
02/15/2021 09:56 AM
02/15/2021 09:56 AM