LinkIQ
Users Manual
26
Do a Switch Test
To do a switch test:
1. Turn on the Product.
2. Connect one end of the CAT6A copper patch cable or other approved cable into the RJ-45
jack on the Product. See Figure 6.
Figure 6. Switch Test Set Up
3. Connect the other end of the patch cable into an RJ-45 jack in an outlet connected to a
switch.
4. If needed, adjust the settings. See Settings Menu.
5. Tap AUTO TEST to do a test.
The results show on the display.
6. On a test result screen, tap SAVE AS.... See Save a Test Result.
Switch Test Results
Ta b l e 1 1 shows possible results of a switch test.
1234 5 6
1234 5 6
02/15/2021 09:56 AM 02/15/2021 09:56 AM
To Next Page
Loading...
