Fluke LinkIQ - Settings Menu Options

Cable+Network Tester
Main Menu
9
Settings Menu
Ta b l e 6 is a list of the options available in the Settings menu. The Product uses the last saved
settings when the Product is turned off and back on.
Tab le 6. S et tings Me nu
Option Menu Option Description
Wire map Settings
Shield Test
Uses the continuity of the shield on the cable to determine if
a test passes.
Even if a shield is connected to a cable, the continuity of the
shield is not used to determine if a test passes. Default
setting.
Allow
Crossover
The wire map of either a straight through cable or a
crossover cable is used to determine if a test passes.
The wire map of a straight through cable is used to determine
if a test passes. A wire map of a crossover cable fails. Default
setting.
Pinout <options>
Select to set the wire color configuration to use to do a test.
T568A is the default setting.
Cable Settings
Te st L i m i t
10BASE-T
Verify if a cable with continuity on at least the 1,2 and 3,6
pairs can support 10BASE-T (10) data rate throughput.
100BASE-TX
Verify if a cable with continuity on at least the 1,2 and 3,6
pairs can support 100BASE-TX (100) data rate throughput.
1000BASE-T
Verify if a 4-pair cable with continuity on all 4 pairs can
support 1000BASE-T (1G) data rate throughput.
2.5GBASE-T
Verify if a 4-pair cable with continuity on all 4 pairs can
support 2.5GBASE-T (2.5G) data rate throughput.
5GBASE-T
Verify if a 4-pair cable with continuity on all 4 pairs can
support 5GBASE-T (5G) data rate throughput.
10GBASE-T
Verify if a 4-pair cable with continuity on all 4 pairs can
support 10GBASE-T (10G) data rate throughput. Default
setting.