Fluke LinkIQ - Cable Test Results and Failures

LinkIQ
Users Manual
18
4. Connect the other end of the patch cable into an RJ-45 jack or into an adapter that is
connected to the near end of the cable under test. Then, connect the Remote ID into an
RJ-45 jack or adapter that is connected to the far end of the cable under test.
Or,
Connect the Remote ID into an RJ-45 jack or into an adapter that is connected to the near
end of the cable under test. Then, connect the other end of the patch cable into an RJ-45
jack or into an adapter that is connected to the far end of the cable under test.
5. Tap AUTO TEST to do a test.
The results show on the display. See Ta b l e 8 .
6. To save the results, tap SAVE AS.... See Save a Test Result.
Cable Test Results
Ta b l e 8 shows examples of results of cable tests.