Fluke LinkIQ - Upload Results to PC

Cable+Network Tester
Upload Results to LinkWare PC
39
Upload Results to LinkWare PC
To upload results to LinkWare PC:
1. If necessary, tap on Home.
2. Connect the USB-C end of the USB cable into the USB port on the Product. See Figure 8.
3. Connect the USB-A end of the USB cable into a USB port on a PC.
4. On a PC, use LinkWare PC to upload results.
Figure 8. Product to PC Connection
Tests with MS-IE-Adapter Set
To do a test with an MS-IE Adapter Set, see the MS-IE-Adapter Set QRG on
www.flukenetworks.com
.