LinkIQ
Users Manual
12
Configure a Static Address
Use the directions below to configure an IPv4 or an IPv6 address to use for the Product or to
use on a device connected to a network.
Change the IP Address of the Product
To change the IP address of the Product:
1. Tap > Network > IPv4 or IPv6 > Static.
With Static selected, the IP, Subnet Mask, Gateway, and DNS buttons show. With Static
selected for both IPv4 and IPv6, a scroll bar also shows.
2. Configure the address. See Configure an IPv4 Address or Configure an IPv6 Address.
Change the IP Address of a Device to Ping
Set up the Product to use either an IPv4 or an IPv6 address of a device to ping, but not both.
To s e t u p a p i n g t e s t:
1. Turn on the Product.
2. Connect the Product to a network.
3. Go to > Ping.
4. If needed, turn on Ping.
5. To change from an IPv4 address to another IPv4 address or from an IPv6 address to
another IPv6 address, tap
U on the IP button and enter the new address. See Configure an
IPv4 Address or Configure an IPv6 Address.
Date/Time <options>
Tap to select options to set the date, time, date format, and
time format.
Language <options> Tap to select a language after initial setup.
About --
Tap to view the serial number, MAC address, and version
information of the Product.
Factory
Reset
--
Tap to delete all test results and reset the Product to the
factory default settings.
Table 6. Settings Menu (cont.)
Option Menu Option Description
To Next Page
Loading...
